When the omnibus test was deemed significant, haplotype-specific test was performed. A conditional haplotype test that controlled for a particular haplotype among a set of haplotypes was also conducted to determine if that particular haplotype alone leads to the significant omnibus association result. Haploview 4.1 [43] was adopted to generate the haplotype block structure for the genotyped markers that passed the quality control requirements. LD is not calculated if markers are greater
than 500 kb apart. Statistical power was estimated by the “Case-Control for threshold-selected quantitative traits” module of the web-based Genetic Power PD0325901 order Calculator (http://pngu.mgh.harvard.edu/~purcell/gpc/qcc.html) [44]. Bioinformatics analysis A comparative genomics approach was adopted to 8-Bromo-cAMP concentration determine potential functional elements in the candidate region associated with BMD variation. The chromosomal position of the region was submitted to the VISTA Genome browser. Pre-computed whole-genome alignment among large vertebrates, which had a high sensitivity in covering more than 90% of known exons, was available on the browser with timely update upon the release of new genome assemblies [45]. The sequence encompassing the significantly associated SNP was scanned against the weight matrices for vertebrates
that were publicly available on MatInspector [46]. RG-7388 solubility dmso The optimized matrix threshold of a weight matrix was defined as the threshold that allowed a maximum of three matches in 10 kb of non-regulatory test sequences. The matrix similarity was calculated on-the-run by scanning the imported sequence against the relative frequency of each
nucleotide at a particular position in the matrix. Only potential binding sites with: (1) matrix similarity exceeding the optimized threshold; and (2) matrix similarity greater than 0.85 were considered good matches. Results Subject characteristics The characteristics of the subjects are outlined in Table 2. Student’s t test was used to compare the mean age, height, weight, and BMD in the case- and control-group, without assuming equal variances. The covariates that showed significant differences between Cepharanthine cases and controls were potential confounding factors for BMD variation. These were adjusted in the subsequent analysis as indicated in Table 2. Table 2 Characteristics and BMD measurements of the 1,080 subjects and the constituent 533 postmenopausal women Whole study population Postmenopausal women Cases Controls p value (t test) Cases Controls p value (t test) Skeletal site: lumbar spine Number 457 254 – 314 107 – Age (year) 51.71 ± 13.78 49.56 ± 14.35 0.05 59.92 ± 5.90 63.55 ± 8.16 <0.01* Height (m) 1.53 ± 0.06 1.576 ± 0.06 <0.01* 1.52 ± 0.057 1.55 ± 0.05 <0.01* Weight (kg) 49.98 ± 7.22 60.34 ± 9.76 <0.01* 51.03 ± 7.43 62.45 ± 9.79 <0.01* BMD (g/cm2) 0.