The elution profile of this column (Figure 3) was monitored by assaying aliquots of each column fraction with ChromeAzurol reagents according to the protocol previously developed by McPhail et al.[12]. The profile exhibited a distinct peak of Cu-binding activity (expected to correspond to compounds containing amino groups) followed by a smaller peak, both of which overlapped an extended peak of Fe-binding activity (reflecting the elution of contaminating phosphate from the culture medium). The fractions corresponding
to the larger peak of Cu-binding activity were pooled, taken to dryness in vacuo, and the recovered solids dissolved in 76% ethanol for preparative TLC fractionation. Following preparative TLC, the area on the TLC plate corresponding to the position of the ninhydrin-reactive compound was scraped from each plate and extracted with deionized ABT-263 concentration selleck chemical water. The combined aqueous extracts were dried in vacuo and dissolved in a small volume of deionized water for rechromatography
on a Sephadex G-15 column. Figure 3 Initial Sephadex G-15 column fractionation of an 85% ethanol extract of dried culture filtrate from Pseudomonas fluorescens SBW25. The solids from 840 mL of dried SBW25 culture filtrate were extracted with 85% ethanol as described in the Linsitinib Methods section. A portion of the extract equivalent to 800 mL of original culture filtrate was taken to dryness in vacuo and dissolved in 6 mL of deionized water for application to a Sephadex G-15 column equilibrated in the same solvent. The column was eluted with deionized water. Fractions (6 mL each) were collected and analyzed for P-type ATPase reaction with the Fe- and Cu-CAS reagents as described in the Methods section. The fractions corresponding to the largest Cu-binding
peak were pooled (as indicated by the double arrow) for concentration and further purification by preparative TLC fractionation. The elution profile for Sephadex G-15 column fractionation of the material recovered from preparative TLC purification exhibited a Cu-binding peak that was clearly separated from a smaller Fe-binding peak, indicating that the ninhydrin-reactive compound was separated from the contaminating phosphate (Figure 4). The fractions from the Cu-binding peak were pooled as indicated, and an aliquot of this pooled material was tested for antimicrobial activity in agar diffusion assays. The tested aliquot strongly inhibited the growth of D. dadantii 1447. The pooled fraction was then taken to dryness and re-dissolved in 76% ethanol. TLC analysis of an aliquot of the 76% solution gave a single ninhydrin-staining band at the expected Rf, and no UV-absorbing or fluorescent compounds were detected. The remainder of the 76% ethanol solution of the purified compound, corresponding to ca. 600 mL of original culture filtrate, was concentrated in vacuo and yielded 3.7 mg of a white amorphous solid, of which 3.