Such precipitates can also affect the HTS resulting in poor liquid dispenses on the automation equipment. Tris buffer contains a free amine group which can react with enzymes and/or substrates, altering the equilibrium of the system. Tris is also able to chelate metal ions which could have

deleterious effects on the activity of enzymes requiring metals for catalysis or structure (Desmarais et al., 2002). There are many subtleties to consider when choosing a detection method for following an enzymatic FG-4592 nmr reaction in HTS, including throughput, sensitivity, cost and assay robustness, as well as the nature of the reaction under investigation and that of the products and/or substrates to be measured. No detection method is perfect – they are all utilized with some caveats – but for most enzyme classes, it is possible to strike a balance between these requirements to develop a useful assay. Many of the methods that are introduced here will be discussed with respect to specific enzyme classes and technologies later in this review. Directly monitoring a reaction as it is happening is referred to as a continuous read. Continuous reading typically requires a spectrophotometer/fluorometer capable of rapidly collecting data Trametinib in vivo from multiple time points and the ability of the

molecules being monitored to absorb or emit light in a reaction dependent way. Some examples of suitable systems used

in continuous detection are observing the change in either absorbance or fluorescence upon the interconversion of NAD and NADH, the production of fluorescent labels such as amino methyl coumarin (AMC) by proteolysis of AMC-labeled peptides, and the ability to observe changes in light scattering upon large protein complex formation. Continuous detection provides the advantage of observing an entire reaction time course G protein-coupled receptor kinase from a single mixture of substrate and enzyme, which minimizes the error in data by minimizing the need for multiple transfers and excess handling of the reaction components. However timing is a key variable that must be controlled particularly if a single time point is chosen for the assay as it can be difficult to stop a continuous reaction without disrupting the system or interfering with detection. In the specific case of fluorescence detection for enzyme assays one method to address “overriding” of the assay signal by compound fluorescence is to measure the reaction progress in a kinetic mode. Unless the reaction under study is slow, on the order of tens of minutes, only fast-scanning readers or whole-plate imagers (such as the PerkinElmer ViewLux™) allow for unbiased and speedy repeated measurements of microtiter plates. However, often a simple method where two-time points are collected allows one to estimate the reaction rate by simple subtraction of the two data points.