However, these techniques require expensive devices and complicated procedures. Moreover, there have been few papers that describe simple post-treatments to further reduce the reflection from the material surface, although some post-treatment methods have been reported including oxygen treatments for improving the abrasion resistance of the coating [15], NH3-heat processes S63845 in vivo followed by a trimethylchlorosilane modification to enhance the scratch resistance and moisture resistance [16], and the effects of heat, laser, and ion post-treatments on HfO2 single layers [17]. Here, we present a hydrogen etching approach to fabricate pyramid-shaped Si nanostructures that exhibits a comparatively low reflectance

at the wavelength regions of ultraviolet (UV) and visible (Vis). The aspect ratio and two-dimensional spacing of Si nanostructures can be controlled by changing the etching condition. In addition, the reflectance was further reduced by depositing a Si-based polymer on the fabricated Si nanostructures, which also induce more uniform selleck chemicals llc reflectance behavior over UV and Vis regions. Methods The

fabrication process of the Si nanostructures is displayed schematically in Figure 1. A polished (100) Si plate (10 × 10 mm2) (p-type; Namkang Hi-Tech Co., Sungnam, South Korea) was washed by isopropyl alcohol (Sigma Aldrich, St. Louis, MO, USA) and dried using nitrogen Tacrolimus (FK506) gas in order to remove impurities on the Si plate. After cleaning the Si plate, the hydrogen etching process was conducted using hydrogen (10%) and argon (90%) mixture gases under 1 × 10−2 Torr at different temperatures (1,350°C, 1,200°C, and 1,100°C). The holding time at the maximum annealing temperature was 30 min and the flow rate of mixture gases was 0.5 standard cubic centimeters per minute (sccm) during the annealing process. Subsequently, a poly(dimethylsiloxane) (PDMS) (viscosity 2,000,000 cSt) (Dow Corning, Jincheon, Chungbuk, South Korea) layer was deposited on the fabricated Si nanostructures through a doctor blade technique [18] to enhance the AR property. The thickness

of the PDMS layer was approximately 1 μm. The morphologies of the fabricated Si nanostructures were characterized using a field emission scanning electron microscope (FESEM; ZD1839 datasheet Hitachi S-4800, Hitachi, Tokyo, Japan). The roughness of the PDMS surface on the Si nanostructures was measured using an atomic force microscope (AFM; XE-70, Park Systems, Ft. Lauderdale, FL, USA). The AR properties of the Si nanostructures were analyzed using a finite difference time domain (FDTD) simulation method and measured using the diffuse reflectance (DR) module of an UV–Vis spectrometer (SCINCO S-4100, SCINCO, Daejeon, South Korea). A xenon (Xe) lamp was used as the light source at wavelengths of 300 to 800 nm. The measurement error of the UV–Vis spectrometer was less than 0.