Figure 4 Load-indentation depth curve of the composite and SEM image of the indentation-induced microcrack. (a) Load-indentation depth curve of the (PE/TiO2)4 nanolayered composite measured by nanoindentation. (b) SEM image showing that indentation-induced

microcrack advanced into the (PE/TiO2)4 nanolayer-coated region, by which fracture toughness of the nanocomposite can be obtained. Following the method to determine the fracture toughness (K IC) of a thin film bonded to a brittle substrate [17], when the indentation load was large enough applied to the Si substrate uncoated by the (PE/TiO2)4 NLC, microcracks initiated from four corners of the indent in the Si substrate and P505-15 purchase advanced into the (PE/TiO2)4 nanolayer-coated region, as indicated by an arrow in Figure 4b. Based on the measurements of the crack length, K IC of the (PE/TiO2)4 NLC was obtained as K IC = 1.62 ± 0.30 MPa · m1/2, which is almost a threefold increase in comparison to that Selleck GF120918 of the single TiO2 layer of approximately 400 nm thick [11]. One reason for the enhancement of K IC of the present NLC was attributed to energy

dissipation via crack deflection along the inorganic/organic interface, as a general mechanism operated in artificial and natural multilayered architectures [11]. Furthermore, since the present (PE/TiO2)4 NLC has an inorganic/ organic layer thickness ratio of about 1.1 and the TiO2 thickness is only 17.9 nm, it is believed that even if a crack initiates in the TiO2 layer with a thickness of 17.9 nm, the NLC would become more insensitive to flaws, as predicted by Gao et al. [12]. The hierarchical structures in biological materials have shown a good synergy of high strength

and good fracture toughness (damage tolerance). Li et al. [19] have revealed that the mineral layer in the nacre consists of nanocrystalline CaCO4 platelets, which facilitates grain boundary sliding. This also implies the GDC-0449 research buy possible activation of the grain boundary sliding mechanism in our NC TiO2 layers during deformation. The present results indicate that building the composite consisted of the amorphous PE and the NC TiO2 layers at nanometer scales may provide a possible strategy toward Ibrutinib ic50 enhancing damage tolerance of the material even if the best optimum ratio of the organic layer to the NC inorganic layer still needs to be found. Conclusions The bio-inspired (PE/TiO2)4 nanolayered composite with an inorganic/organic layer thickness ratio of about 1.1, which consisted of nanocrystalline TiO2 and amorphous PE layers with thicknesses of 17.9 and 16.4 nm, respectively, was prepared on a Si (001) substrate by LBL self-assembly and CBD methods. The (PE/TiO2)4 nanocomposite has a strength of about 245 MPa, being close to that of the natural shell, while the fracture toughness of the nanocomposite, K IC = 1.62 ± 0.30 MPa · m1/2, is evidently higher than that of the single TiO2 of about 400 nm thick.