Characterizations Scanning electron microscopic (SEM) images are recorded on a Hitachi S-3000N instrument (Tokyo,

Japan) at 15 kV. The samples are cut with a scalpel and coated with a thin layer of gold using an ion sputter apparatus (E-1010 Ion Sputter, Hitachi Ltd, Tokyo, Japan). Nitrogen adsorption/desorption isotherms selleck screening library are measured with a NOVA 4200e surface area and pore size analyzer (Quantachrome Instruments, Boynton Beach, FL, USA) at 25°C. The Brunauer Emmett Teller (BET) method is utilized to determine Stem Cells inhibitor specific surface areas. Before the measurements, all samples are degassed at 25°C for 12 h under vacuum. Fourier transform infrared (FT-IR) measurements by the attenuated total reflectance (ATR) method are performed using the Thermo Scientific (Yokohama, Japan) Nicolet

iS5 with iD5 ATR accessory. Porosity of the monolith samples is measured using a gravimetric method according to the following equation: where V 1 is the volume of a certain weight of the PVA/SA blend powder and V 0 is the volume of the same weight of PVA/SA blend monolith. The Kinase Inhibitor Library price pH-sensitivity of PVA/SA blend monolith samples is evaluated on the basis of the swelling ratio in a solution with different pH, which is determined by the following equation [14]: where W e and W b are the weights before and after immersion, respectively. Results and discussion The general synthetic procedure is shown in Figure 1. For the fabrication process, selection of non-solvent and the ratio of solvent and non-solvent are crucial factors for the formation of the blend monolith. The detailed screening of the phase separation solvent shows that a mixture of water and methanol with a ratio of 2:3 is the most suitable. Intriguingly, the PVA monolith with good mechanical strength is not formed in this solvent. When the methanol ratio of the mixed solvent is more than 60%, the precipitation takes place very quickly during the phase separation, resulting in no formation of the monolith. On the other hand, no phase separation occurs when the methanol ratio is less

than 60%. These behaviors can be rationalized as follows. After adding methanol into the polymer solution, the mixed solvent system transforms into polymer-rich phase and polymer-lean phase. As the amount of non-solvent (methanol) increases, the polymer segments Urease in the polymer-rich phase become folded and aggregated, leading to the increase of the concentration in the polymer-rich phase. When the increasing concentration reaches to a certain degree, the phase separation takes place. In the case of a smaller amount of non-solvent, the concentration of polymer-rich phase is not high enough to induce the phase separation; while for a much larger amount of non-solvent, a mass of polymer segments aggregate rapidly, resulting in precipitation of the polymer in the phase separation system. Figure 1 Fabrication process of PVA/SA blend monolith via TINIPS.