Based on the results in Fig  2b, the remaining experiments were c

Based on the results in Fig. 2b, the remaining experiments were conducted employing

initial solution pH = 6. Also, this close-to-neutral pH was selected to avoid the possibility of leaching of organic matter from the adsorbent that might occur at the lower or higher ends of the pH scale. The influence of adsorbent dosage on the efficiency of phenylalanine removal can be viewed in Fig. 2c. Removal efficiency increased with the increase in adsorbent dosage (mass), being attributed to the increase in surface area. However, the amount of PHE adsorbed per unit mass of adsorbent decreased with increasing adsorbent mass, due to the increase in adsorbate/adsorbent ratio. Thus, the remaining experiments were conducted with an adsorbent dosage of 10 g L−1, given that lower dosages did not present satisfactory Veliparib Idelalisib cell line adsorption efficiency (PHE removal percentage) whereas higher dosages led to a significant decrease in adsorption capacity. The adsorption data presented in Fig. 3 show that adsorption presents a strong dependency on PHE initial concentration and that a contact time of 4 h assured attainment of equilibrium conditions for all initial PHE concentrations.

An increase in the initial PHE concentration led to an increase in total amount adsorbed, due to the corresponding increase in driving force (PHE concentration gradient). Regardless of the initial PHE concentration, adsorption can be described by a two-stage kinetic behavior, with a rapid initial adsorption during the first 15 min,

followed by a slower rate afterward. The faster initial PHE adsorption could be an indication that the resistance to bulk diffusion is negligible in comparison to the resistance to intra-particle diffusion. The same qualitative behavior was observed for experiments conducted at higher temperature values. The controlling mechanism of the adsorption process was investigated by fitting pseudo first and second-order kinetic models to the experimental data (Ho, 2006): equation(3) Pseudofirst-order:qt=qe(1−e−k1t) Urocanase equation(4) Pseudosecond-order:tqt=1k2qe2+tqewhere qe and qt correspond to the amount of PHE adsorbed per unit mass of adsorbent (mg g−1) at equilibrium and at time t, respectively, and kn is the rate constant for nth order adsorption (kn units are h−1 for n = 1 and g mg−1 h−1 for n = 2). The results for the fits of the kinetic models and their estimates for equilibrium adsorption capacity are displayed in Table 2. The best-fit model was selected based on both the regression correlation coefficients (r2) and the difference between experimental (qt,exp) and model-estimated (qt,est) values, evaluated by a root mean square error measure: equation(5) RMS(%)=100∑[(qt,est−qt,exp)/qt,exp]2/Nwhere N is the number of experimental points.

Comments are closed.