5-mm probe at the spin rate of click here 20 kHz. A current–voltage curve was obtained using a source measure unit (model 2400, Keithley Instruments Inc., Cleveland, OH, USA) under the illumination of a solar simulator with air mass 1.5 global (AM 1.5 G) filters at 100 mW/cm2. The light intensity of the solar simulator was calibrated with a standard silicon diode. Results and discussion The optical microscopic image of the TNP patterns in the FTO regions on the substrate is shown in Figure  2b where TNP patterns isolated from the neighboring patterns were clearly seen. Each isolated TNP pattern, which is 500 μm wide and 14 mm

long in the interval of 500 μm, selleck products represents an individual photoanode for a unit cell in the SS-DSSC array [14, 15]. Figure  2c shows the FE-SEM image of the cross-sectional TNP pattern. According to the FE-SEM image, each TNP pattern was about 2.5 μm thick. This is a typical thickness of the TNP photoanode for a whole SS-DSSC [12]. Moreover, as shown in Figure  2d, the TNPs were highly

packed in the multistacks of a few micrometers, and the surface roughness was about a few tens of nanometers. It should be noted that our micropatterning method based on the SL lift-off process is very simple and effective to produce a wide range of the TNP patterns by varying the thickness of the doctor-bladed TNP layer and the dimension of the SL patterns transfer-printed by the PDMS stamp. For lifting-off the SL, the FTO substrate with the TNP patterns was exposed to a fluorous solvent. From the measurements of the

19 F-NMR spectrum of the TNP sample treated by a fluorous solvent, no this website extra peak was observed when compared to an empty rotor, as shown in Figure  2f. This tells us that no remnant solvent exists after annealing the TNP sample at 450°C, and thus, the SL lift-off process is contamination free for patterning the multistacks of TNPs in the fabrication PtdIns(3,4)P2 of the array of the SS-DSSCs. Figure  3 shows the array configuration of three DSSCs connected in series together with a cross-sectional view of a unit cell consisting of the FTO layer, TNPs with dyes, HTM, and Au electrode. For the series connection, the Au cathode in a certain unit cell is connected to the patterned FTO layer in the adjacent unit cell. In describing the charge flow in the unit DSSC, when the incoming light is absorbed by the photosensitizing dyes, the electrons are injected into the conduction band of the TNPs and move toward the FTO electrode. Meanwhile, the oxidized dyes are reduced by the HTM which is regenerated at the Au cathode [16]. Figure 3 Schematic diagram showing an array of three SS-DSSCs connected in series and a unit cell. Figure  4a,b shows the current–voltage curve of a single SS-DSSC and that of the array consisting of 20 SS-DSSCs measured under the illumination of simulated AM 1.5 G solar light (100 mW/cm2).