25TiO3 ceramics was hypothesized to be the effect of either large induced internal electric fields within the thin Ba0.75Sr0.25TiO3 layer sandwiched by electrode-like metallic Ag particles or improved densification of ceramic composites. However, E b of a metal-ceramic composite abruptly decreased as the metallic filler concentration increased to PT [4]. LY2603618 cost CaCu3Ti4O12 (CCTO) is one of the most interesting ceramics because it has high ϵ′ values. CCTO polycrystalline ceramics can also exhibit non-Ohmic properties

[12–20]. These two properties click here give CCTO potential for applications in capacitor and varistor devices, respectively. Unfortunately, high tanδ (>0.05) of CCTO ceramics is still one of the most serious problems preventing its use in applications [10, 12, 17]. The application of CCTO ceramics in varistor devices was limited by their low nonlinear coefficient (α) and

E b values. For energy storage devices, both ϵ′ and E b need to be enhanced in order to make high performance energy-density capacitors. Therefore, investigations to systematically improve CCTO ceramics properties are very important. Methods In this work, CaCu3Ti4O12 powder was prepared by a INCB28060 mouse solid state reaction method. First, CaCO3, CuO, and TiO2 were mixed homogeneously in ethanol for 24 h using ZrO2 balls. Second, the resulting mixture was dried and then ground into fine powders. Then, dried powder samples were calcined at 900°C for 6 h. HAuCl4, sodium citrate, and deionized water were used to prepare Au NPs by the Turkevich method [21]. CCTO/Au nanocomposites with different Au volume fractions of 0, 0.025, 0.05, 0.1, and 0.2 (abbreviated as CCTO, CCTO/Au1, CCTO/Au2, CCTO/Au3, and CCTO/Au4 samples, respectively) were prepared. CCTO and Au NPs were mixed and pressed into pellets. Finally, the pellets were sintered in air at 1,060°C

for 3 h. X-ray diffraction (XRD; Philips PW3040, Philips, Eindhoven, The Netherlands) was used to characterize the phase formation of sintered CCTO/Au nanocomposites. Scanning electron microscopy (SEM; LEO 1450VP, LEO Electron Microscopy Ltd, Cambridge, UK) coupled with energy-dispersive X-ray spectrometry (EDS) were used to characterize the microstructure of these Thymidylate synthase materials. Transmission electron microscopy (TEM) (FEI Tecnai G2, FEI, Hillsboro, OR, USA) was used to reveal Au NPs. The polished surfaces of sintered CCTO/Au samples were coated with Au sputtered electrode. Dielectric properties were measured using an Agilent 4294A Precision Impedance Analyzer (Agilent Technologies, Santa Clara, CA, USA) over the frequency range from 102 to 107 Hz with an oscillation voltage of 0.5 V. Results and discussion Figure 1 shows the XRD patterns of the CCTO/Au nanocomposites, confirming the major CCTO matrix phase (JCPDS 75–2188) and the minor phase of Au filler (JCPDS 04–0784). An impurity phase of CaTiO3 (CTO) was also observed in the XRD patterns of the CCTO/Au samples.